Dirt Town Auto Grade Guide: Lock a Dozer Blade to Grade and Build Smooth Roads
Learn how the Dirt Town auto grade tools work: setting earth stakes, locking the dozer blade to grade, and laying gravel lifts that stay level.
What "Dirt Town Auto Grade" Actually Means
Dirt Town gives you a dozer, a slope, and a job that sounds simple until the first bucket: build a road that stays flat. Anyone who has spent twenty minutes fighting a blade knows the difference between a clean ramp and a rutted mess usually comes down to one thing — how well the Dirt Town auto grade setup is prepared before you push a single load.
That's why so many new players go looking for a "Dirt Town auto grade" tutorial after their first failed road. The game doesn't hand you a machine with satellite guidance. It hands you earth stakes and a blade mode, and the rest is technique. Get those two pieces working together and you can cut a ramp from an 8-unit high point down to a 2-unit low point in a couple of passes instead of an afternoon of guessing.
This guide walks through how the grade tools behaved in the demo build shown on the Dirt Town Steam store page, using hands-on observations from the Baker Pro D demo video where grading and gravel placement were demonstrated step by step.
How to Set Up Earth Stakes for an Auto Grade Road
The earth stake is the foundation of the whole system. In the demo footage, the creator carries one in hand, places it on the ground, and presses E to read the local elevation — one spot measured 7.3, and he then nudged the value slightly to 7.36 before committing. That number becomes a fixed reference point you can cut toward.
The practical workflow that emerged in the video looks like this:
- Place the first stake at the top of the run. Read the value, then lock in a number close to it (7.3 or 7.36 in the example).
- Move across the working width and place a second stake at the same value. Matching values create a level pad rather than a slope.
- Place a third stake downslope with a different value. In the video a lower position read around 2.01, which established a consistent fall from roughly 7.3 at the top to 2.01 at the bottom.
- Hold E on any stake to remove it when you're done or when you need to re-plan the run.
That last step matters more than it sounds. The creator repeatedly wished he could keep a wide visual guide on screen so he could see how wide the road was going to be, and the stakes kept vanishing as he worked. Players report the same frustration — plan your width before you start pushing, because the markers won't do it for you.
Dozer Blade Locked to Grade: Controls and Offsets
The second half of the Dirt Town auto grade system lives on the dozer. Pressing J cycles the blade between modes: blade on the sticks, blade tilt free, and blade locked to the grade. Locked mode is the "auto grade" behavior — the blade holds the slope you established with the stakes, so you only steer and manage load.
| Action (demo build) | What it does |
|---|---|
| Press E on an earth stake | Shows the grade value for that spot |
| Hold E on a stake | Removes the stake |
| J | Cycles blade modes, including blade locked to the grade |
| Comma and period keys | Raise or lower the blade offset while grade lock is active (+10, +20, and so on) |
Control mappings can change between builds, so treat this as a snapshot of the demo rather than a permanent keybind list.
The offset keys are the detail most players miss. In the video, the creator used them to lift the blade by increments of 10 and then 20 while grade lock stayed active, which let him skim the top off a pile without switching modes on and off every pass. He also pointed out that reversing with the blade still on the ground means you're back-blading the surface you just cut — lifting the blade before you back up keeps the grade cleaner.
One more habit worth copying: push downhill whenever the map allows it. The creator noted that pushing uphill means fighting gravity and the load at the same time, so laying out a run from high ground to low ground saves real effort.
Gravel Lifts: 10, 20, 30, or 50?
Once the dirt grade is cut, the video shows a clever trick for capping it: raise the grade by a set offset at each end, dump gravel at the top, and push it down with the blade still locked. The result is a gravel layer of consistent thickness across the whole ramp instead of a lumpy spread.
| Offset tried | Result reported in the demo video |
|---|---|
| 10 | Too thin — dirt still showed through the surface |
| 20 | Noticeably better coverage |
| 30 | Called the practical middle ground — faster to push through |
| 50 | Smoothest result, but slow to fill across the full length |
The takeaway isn't a magic number. It's that the offset method lets you choose surface thickness deliberately, then reproduce it on the next ramp. Players working the same demo have reported that gravel compacts under repeated passes, so expect to top up wheel ruts after heavy hauler traffic — especially on softer ground.
That softness is a real factor in the cited creator footage. The Dirt Town Demo page on Steam separately documents moisture affecting grip and dirt movement and water that flows. For reference only, the creator saw trucks sink and ruts form near the water line; Steam does not state that proximity to water directly changes terrain moisture. In that footage, a thicker gravel lift helped the wet section, so treat that as player experience rather than a general simulation rule.
Where Grade Work Goes Wrong
A few failure patterns showed up repeatedly in the demo footage, and they're worth checking before you blame the tools:
- Not enough dirt in the cut. The creator abandoned one ramp plan outright because there simply wasn't enough material ahead of the blade to fill the low side. Scout the volume before you set stakes.
- Pushing too much at once. Big loads bogged the dozer down and tanked performance in the demo build, which the Steam page notes is still being optimized.
- Trees and rocks in the line. In the build shown, trees could no longer be moved with the loader, so the creator had to work around them or break them with the blade. Rocks mixed into the fill are also audible as they hit the steel.
- Assuming the surface is finished. Driving the truck over freshly laid gravel re-cut ruts immediately. The video's creator expected a roller-type machine or asphalt layer to become valuable later, but neither was available in that build.
The broader design direction matters here too. The creator described Dirt Town as leaning toward road-building rather than pure mining, and the Steam demo objectives back that up: build a road to find sand, haul sand to test whether your road holds, find a hidden vehicle, and jump the river. Grading well isn't side content — it's the core loop.
Demo Scope and Early Access Status
As of 2026-11-16, the games-stats.com Steam statistics page for Dirt Town listed a release date of December 4, 2026, tagged Early Access and marked "Coming Soon," with Skyturns shown as both developer and publisher. That same snapshot listed no price, no review score, and no follower count — all shown as N/A — so there is no meaningful review data to weigh yet.
The same page described multiplayer for up to four players, with Early Access, Indie, and Simulation listed as genres. The demo itself ships with a dozer, a wheel loader, a hauler, and a hidden vehicle to find. The earlier demo video's creator expected early access around December 4 as well, though that was his own expectation rather than a confirmed announcement on camera.
Because Dirt Town auto grade behavior was still shifting between builds — the creator mentioned updates landing two to three times a day during that test period — check the live store listing and patch notes before you assume a keybind or offset value is final.
FAQ
Does Dirt Town auto grade work without earth stakes? No. The stake readout is what establishes the reference slope. Blade lock holds a grade, but you have to set the grade with stakes first or you're just holding an arbitrary angle.
Which key locks the dozer blade to grade in Dirt Town? In the demo build shown in the Baker Pro D video, pressing J cycles blade modes until you reach "blade locked to the grade." Verify the binding in your own build, since controls changed between demo updates.
How thick should my gravel layer be? The creator found an offset of 10 too thin and 20 noticeably better, with 30 speeding up the push and 50 giving the smoothest but slowest result. For reference only, that footage showed thicker gravel helping on wet ground near water; Steam does not state that proximity to water directly changes terrain moisture.
Is Dirt Town auto grade a permanent feature? It was present in the demo build used for the footage above. Given that the game was still in demo and pre-early-access development, treat every control and offset value as version-specific and confirm against the current Dirt Town store page.
Related Guides
Dirt Town Bench Cutting: What the Mining Sim Demo Reveals About Moving Earth
Dirt Town bench cutting, explained: what the free demo coverage confirms, what it leaves open, and how real bench-cutting habits transfer to the sim.
Dirt Town Bridge Over River Guide: Stakes, Fill, and Dozer Tips
Plan the Dirt Town bridge over river build with grade stakes, dirt fill, and dozer passes, plus beta lessons from a real playthrough.
Dirt Town Build Road Over River: Demo Tips for a Road That Holds
Learn to build road over river mud in Dirt Town with a gravel base, dozer grading, and moisture-aware hauling tips from the free demo.
Dirt Town Building a Ramp: How to Shape a River Jump Runway in the Demo
Build a ramp that actually clears the river in the Dirt Town demo: runway prep, gravel layers, dozer controls, grade stakes, and fixes.